Cannon DIGI-TROLL 10 TS Bedienungshandbuch PDF herunterladen (Seite 7)

www.cannondownriggers.com

Installation

Decks thinner than 1/4”

Use a Cannon deck plate (PN

2200693) to prevent deﬂ ection and add stability to decks

thinner than 1/4”. Use the deck plate as a template to

mark the hole locations.

If access to the underside of

the deck is not available, the deck plate can be mounted

using screws and wellnuts. Use the deck plate as a

template to mark locations and drill 4 wellnut clearance

holes. Use four 1/4-20 x 1-1/2” ﬂ at head screws and four

wellnuts to mount deck plate. Tighten the screws so the

wellnuts are ﬁ rmly compressed.

Where the underside is accessi-

ble, the deck plate can be mounted using screws, nuts,

and washers. Drill 9/32” holes. Use four 1/4-20 x 1-1/2”

ﬂ at head screws, nuts and washers (ﬂ at and lock). Fas-

ten plate to deck. To secure the mounting base to the

deckplate use four 1/4-20 x 1” truss head screws.

NOTE: When using the telescopic boom, we strong-

ly recommend the use of a deck plate on all boats to

provide adequate stability for the downrigger.

The Low-Proﬁ le Swivel Base mounting follows the same

procedure as for the deck plate except that four 1/4”-

20 x 1-1/2” truss head screws are used to fasten the

mounting base and four additional 1/4”-20 x 2” truss

head screws ﬁ x the swivel base to the boat deck.

Low-Proﬁ le Swivel Base

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Keine Kommentare

Cannon DIGI-TROLL 10 TS Bedienungshandbuch Seite 7