Cannon DIGI-TROLL 10 TS Bedienungshandbuch PDF herunterladen (Seite 29)

www.cannondownriggers.com

How the Positive Ion Control System Works

The PIC system uses an internal circuit

that passes the voltage through the drive train of the

Digi-Troll to the shaft. The shaft contacts the cable

by means of a ball bearing, spring and, lastly, a one

direction button head screw. Care must be taken to

ensure contact between the cable and the screw when

replacing the cable. When using coated cable, 3-4 ft of

coating must be striped when terminating the cable to

reel. Take care in ensuring that the striped portion is in

contact with the button head screw.

The Positive Ion Control system ap-

plies a variable 0.2 to 1.2 volts on the trolling cable at all

times.

Measuring the Natural Electrolysis and PIC Voltage

on Your Boat

A voltmeter with a scale of zero to one

volt will measure the natural electrolysis. Place the

ground lead of the meter on the motor or the battery

ground. Place the positive lead on the stainless steel

downrigger cable while it is in the water. The downrigger

must be unplugged. The voltage you measure on the

volt meter is your boat’s natural electrolysis voltage. Use

the same set up to measure the PIC voltage; just plug in

the Digi-Troll and adjust the PIC voltage desired.

Using Positive Ion Control

Positive Ion Control is very effective

when trolling. The zone of attraction created at the

downrigger wire will attract the ﬁ sh. It is best to use a

short drop back between the downrigger release and the

lure. Drop backs of 10 to 20 ft. are typical. A drop back

of 50 to 100 ft. will entirely negate the effects of the PIC

circuit. Fishing depths greater than 125 ft. may require a

slightly higher PIC voltage. If you return to shallow water

ﬁ shing remember to turn the PIC voltage down again.

The correct PIC setting for best ﬁ shing

advantage varies, depending on ﬁ sh type and location.

To fully beneﬁ t from PIC technology, it is important that

you experiment with the PIC setting to ﬁ nd the proper

voltage for the gameﬁ sh in the area.

Maintaining Your Downrigger

Periodically, lightly grease the thrust

bearing and bearing race found behind the clutch knob.

Replace the cable at least every two years.

There are no user serviceable parts internal to the

Digi-Troll. Your warranty will be void if opened by

anyone other than an authorized or factory service

center. For repairs or servicing your downrigger

refer to the Warranty Information section of this

booklet.

Positive Ion Control Theory

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Cannon DIGI-TROLL 10 TS Bedienungshandbuch Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Cannon DIGI-TROLL 10 TS