Cannon DIGI-TROLL 10 TS Bedienungshandbuch PDF herunterladen (Seite 27)

www.cannondownriggers.com

Networking your Digi-Trolls

Up to six Digi-Troll series downriggers can be networked together. The units can either be network together with the

optional transducer or networked together with the Cannonlink accessory. To network your downriggers you will need

the Relay Cable Accessory (019634) between each downrigger you would like to link. To link using the transducer, in-

stall and hook up tranducer as described in the Transducer Cable Routing section. Once the transducer is hooked up

to the ﬁ rst downrigger, install the Relay Cable Accessory from the initial downrigger Data Out connector on the back

of the downrigger to the Data In connector on the next downrigger. Repeat for all connected downrigger. To network

the downriggers using Cannonlink, the Cannonlink cable will install to the Data In connector on the ﬁ rst downrigger.

Connect all other downriggers by connecting the Relay Cable Accessory from the Data Out to the Data In of the next

downrigger. A terminator is needed on the last downrigger Data Out in order for the downriggers to properly commu-

nicate. This terminator is included in the Cannonlink accessory.

Optional Intellitroll Accessory

The Digi-Troll series is compatible with the Cannon Intellitroll Speed and Temp sensor. The Intellitroll sensor gives

the user the speed, temperature, and depth at the weight. With the Digi-Troll 10, this information is displayed on the

built in LCD display. The Digi-Troll 10 will automatically recognize the Intellitroll when the Intellitroll is powered up.

DATA OUT

DATA IN

CIRCUIT BREAKER

POWER CABLE

FIGURE 30

DISPLAYED INTELLITROLL DATA

Getting Started

FIGURE 31

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Keine Kommentare

Cannon DIGI-TROLL 10 TS Bedienungshandbuch Seite 27